Operating Instructions
Table Of Contents
-  WARNING
- Compliance Information
- Before first use
- Connection/Installation
- Preparing the app and the batteries
- Mounting the RTK kit on the aircraft and assembling the aircraft
- Installing the base station
- Preparing the remote controller and the aircraft
- Preparing a camera
- Mounting the gimbal on the aircraft
- Mounting a camera on the gimbal (when using the GBL-PX1)
- Mounting a camera on the gimbal (when using the GBL-T3)
- Settings/Operation
- Storing
- Flight Information and Specifications
- Compliance Information
20
3 Place the antenna units for aircraft on the aircraft.
Place the antenna units for aircraft on the left and right sides of the aircraft so that they
cover the damping plate.
4 Secure the damping plate and the antenna units for aircraft using the
hex screws included with this product.
Secure the screws using the hex wrench (H2.5 mm) (0.1 in.) included in the gimbal set (sold
separately).
Attach at two positions
on each leg (eight total).
Notes
• Tighten the screws firmly using the hex wrench included in the gimbal set (sold separately). Otherwise, the
screws may loosen and detachment may occur during flight.
• When using tools other than the hex wrench included in the gimbal set (sold separately), be sure to tighten
the screws with a torque of 1.5 ±0.5 Nm.
• Be sure to use the hex screws included with this product. The hex screws included with the gimbal set (sold
separately) are too short to secure the damping plate and the antenna units for aircraft.