Operating Instructions
Table Of Contents
-  WARNING
- Compliance Information
- Before first use
- Connection/Installation
- Preparing the app and the batteries
- Mounting the RTK kit on the aircraft and assembling the aircraft
- Installing the base station
- Preparing the remote controller and the aircraft
- Preparing a camera
- Mounting the gimbal on the aircraft
- Mounting a camera on the gimbal (when using the GBL-PX1)
- Mounting a camera on the gimbal (when using the GBL-T3)
- Settings/Operation
- Storing
- Flight Information and Specifications
- Compliance Information
22
Rear of aircraft
Connect the power cable (aircraft — gimbal) to the POWER port.
Connect the USB Type-C® cable (aircraft — gimbal) to the USB port.
USB
ANT R
ANT L
EXT CTRL
SD
POWER
LOCKOPEN
FRONT
POWER
POWER
Note
A locking mechanism is used on the control cable (aircraft — gimbal) and power cable (aircraft — gimbal). Insert
fully until the plug locks into place.
[7] Bringing the antenna cables out toward the antenna units for aircraft
1 Pass the antenna cable in a counterclockwise direction around the
mounting part of the landing gear and bring it out toward the antenna
unit for aircraft.
2 Bring the other antenna cable out toward the antenna unit for aircraft
in the same manner.