Operating Instructions
Table Of Contents
-  WARNING
- Compliance Information
- Before first use
- Connection/Installation
- Preparing the app and the batteries
- Mounting the RTK kit on the aircraft and assembling the aircraft
- Installing the base station
- Preparing the remote controller and the aircraft
- Preparing a camera
- Mounting the gimbal on the aircraft
- Mounting a camera on the gimbal (when using the GBL-PX1)
- Mounting a camera on the gimbal (when using the GBL-T3)
- Settings/Operation
- Storing
- Flight Information and Specifications
- Compliance Information
28
2 Connect the micro USB OTG cable to the micro USB port (USB-B) of the
remote controller.
Micro USB port
(USB-B)
3 Peel the release paper off the fixing sheet attached to the micro USB
OTG cable, and stick the fixing sheet on the back of the remote
controller.
Before doing so, wipe any dust or debris off the area where the fixing sheet is to be stuck
using a soft, dry cloth. Then, align the edge of the fixing sheet with the part separation line
on the remote controller and attach the fixing sheet securely.
Part separation lineWipe off any dust or debris.
Notes
• Be sure to attach the fixing sheet to ensure stable communication between the antenna unit for base station
and the remote controller.
• Do not detach the micro USB OTG cable once it is attached.
• Once the fixing sheet peels off, it cannot be reused because it loses its adhesive strength. If you need to
replace the fixing sheet, such as in cases where the fixing sheet has peeled off, please refer to “If the fixing
sheet becomes detached from the remote controller” (page 55).