Operating Instructions
Table Of Contents
-  WARNING
- Compliance Information
- Before first use
- Connection/Installation
- Preparing the app and the batteries
- Mounting the RTK kit on the aircraft and assembling the aircraft
- Installing the base station
- Preparing the remote controller and the aircraft
- Preparing a camera
- Mounting the gimbal on the aircraft
- Mounting a camera on the gimbal (when using the GBL-PX1)
- Mounting a camera on the gimbal (when using the GBL-T3)
- Settings/Operation
- Storing
- Flight Information and Specifications
- Compliance Information
45
Connection/Installation
[2] Connecting the flash sync relay cable to the gimbal and securing it
1 Connect the flash sync relay cable to the AUX port of the gimbal.
Flash sync relay cable
2 Secure the flash sync relay cable to the bottom part of the gimbal
frame with the hook-and-loop fastener.
Pass the hook-and-loop fastener under the frame, turn it forward, and then pass it over the
frame to bundle it. Bundle it on the left side of the groove on the frame when viewed from
the rear.
Hook-and-loop
fastener
Notes
• When storing the gimbal in the packing box, do not remove the flash sync relay cable. Leave it secured to the
gimbal.
• The flash sync relay cable should be bent down at the connector end and secured using the hook-and loop-
fastener along the underside of the gimbal frame. If the cable is secured on the upper side of or right beside
the gimbal frame, the USB cable to be connected in a subsequent procedure may stick up and be unable to
be connected properly.