Operating Instructions
Table Of Contents
-  WARNING
- Compliance Information
- Before first use
- Connection/Installation
- Preparing the app and the batteries
- Mounting the RTK kit on the aircraft and assembling the aircraft
- Installing the base station
- Preparing the remote controller and the aircraft
- Preparing a camera
- Mounting the gimbal on the aircraft
- Mounting a camera on the gimbal (when using the GBL-PX1)
- Mounting a camera on the gimbal (when using the GBL-T3)
- Settings/Operation
- Storing
- Flight Information and Specifications
- Compliance Information
46
[3] Mounting a camera on the gimbal
1 Place the camera in the gimbal.
Loosen the locking screws on both sides of the gimbal frame, extend the tilt top bar to make
it higher, and place the camera in the gimbal from the front. Slide the camera plate attached
to the camera into the groove on the bottom part of the frame.
Locking screw
Tilt top bar
Locking
screw
2 Secure the camera in the gimbal.
Lower the tilt top bar, tighten the locking screws on both sides, and tighten the top camera
screw on the hot shoe cable screw. Tighten the lever on the bottom of the frame to secure
the camera.
Top camera
screw
Lever
Note
Be careful not to get your fingers caught in the tilt top bar when securing the camera in the gimbal.