4-226-572-11(1) Micro Satellite System Operating Instructions Owner’s Record The model and serial numbers are located on the rear of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No. SA-VE230 Serial No.
WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Table of Contents Hooking up the system ......................... 4 Positioning the speakers ........................ 6 Listening to the sound ........................... 7 Adjusting the sound .............................. 7 Precautions .............................................. 8 Troubleshooting ..................................... 9 Specifications ........................................ 10 About this model The SA-VE230 is a 5.
Hooking up the system Connect the speaker system to the speaker output terminals of an amplifier. Make sure power to all components (included the subwoofer) is turned off before starting the hook-up.
Notes • Make sure the plus (+) and the minus (–) terminals on the speakers are matched to the corresponding plus (+) and minus (–) terminals on the amplifier. • Be sure to tighten the screws of the speaker terminals securely as loose screws may become a source of noise. • Make sure all connections are firm. Contact between bare speaker wires at the speaker terminals may cause a short-circuit.
Setting the speakers Positioning the speakers To prevent speaker vibration or movement while listening, attach the supplied foot pads to the bottom four corners of the center speaker, front speakers, and rear speakers. Front/Rear speakers Location of each speaker Center speaker Center Subwoofer Front (Left) Front (Right) Foot pads Setting the center speaker Set the center speaker firmly on top of the TV set, making sure it is completely level.
Listening to the sound LEVEL POWER MIN POWER Slight adjustments to the system can enhance your sound enjoyment. MODE MOVIE Adjusting the sound MUSIC MAX Adjusting the subwoofer POWER indicator First, turn down the volume on the amplifier. The volume should be set to minimum before you begin playing the program source. 1 Turn on the amplifier and select the program source. 2 Press POWER on the subwoofer. LEVEL MOVIE MIN 1 Play the program source.
Setting your amplifier to enjoy movies For the Dolby Digital (AC-3) If your amplifier is connected internally or externally with a Dolby Digital (AC-3) processor, you should use the setup menus for the amplifier to specify the parameters of your speaker system. See the table below for the proper settings. For details on the setting procedure, refer to the manual that was provided with your amplifier.
On placement • Do not set the speakers in an inclined position. • Do not place the speakers in locations that are: — Extremely hot or cold — Dusty or dirty — Very humid — Subject to vibrations — Subject to direct sunlight Troubleshooting Should you encounter a problem with your speaker system, check the following list and take the indicated measures. If the problem persists, consult your nearest Sony dealer.
Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: with 6 ohm loads both channels driven, from 20 - 150 Hz; rated 50 watts per channel minimum RMS power, with no more than 0.8% total harmonic distortion from 250 milliwatts to rated output.
Sony Corporation Printed in China