manual

47
US
Additional Information
SHAKE-X30/SHAKE-X10.US.4-691-057-13(1)
GUEST
The system has become a Party
Guest as the Party Chain function
has been activated by a Party Host.
HOST
The system activated the Party
Chain function and has become a
Party Host.
NO DEVICE
No USB device is connected or
unsupported device is connected.
NO DISC
There is no disc in the unit.
NO MUSIC
No supported audio files exist in the
playback source.
NOT IN USE
You tried to perform a specific
operation under conditions where
that operation is prohibited.
NOT SUPPORTED
An unsupported USB device is
connected, or the USB device is
connected through a USB hub.
OVER CURRENT
An over current from the
(USB)
port was detected.
PROTECTED
The USB device is write-protected.
PUSH STOP
You tried to perform an operation
that can be performed only when
the playback is stopped.
READING
The system is reading information
of the disc or USB device. Some
operations are not available.
REC ERROR
The transfer did not start, stopped
partway, or otherwise could not be
performed.
TRACK FULL
You cannot transfer onto the USB
device because the number of files
has reached its maximum.
Precautions
When carrying the unit
To avoid damaging the disc
mechanism, perform the following
procedure before carrying the unit.
Use the buttons on the unit to
perform this operation.
1 Press  to turn on the system.
2 Press FUNCTION repeatedly to
select “CD”.
3 Remove the disc.
Press  to open and close the disc
tray.
Wait until “NO DISC” appears on the
display.
4 Unplug the AC power cord (mains
lead).
Notes on discs
••
Before playing, wipe the disc with a
cleaning cloth from the center outward
to the edge.
••
Do not clean discs with solvents, such
as benzine, thinner, or commercially
available cleaners or anti-static spray
intended for vinyl LPs.
••
Do not expose discs to direct sunlight
or heat sources such as hot air ducts,
nor leave them in a car parked in direct
sunlight.