User Guide
Table Of Contents
- Table of Contents
- Overview
- Preparation
- Operating the Camera
- Administrator and User
- Logging in to the System
- Configuration of Main Viewer
- Main menu
- Control panel section
- Monitor image
- Plug-in free viewer
- Using SolidPTZ function
- Controlling via the control panel (Operation common to Area zoom mode and Vector dragging mode)
- Panning and tilting by clicking the monitor image (Area zoom mode only)
- Panning, tilting and zooming by specifying the area (Area zoom mode only)
- Panning and tilting by dragging the screen (Vector dragging mode only)
- Moving the camera to a preset position (Common operations in Area zoom and Vector dragging modes)
- Using pan/tilt/zoom operations with the displayed control bar (PTZ Control bar only)
- Controlling the Camera on a Full Image
- Using the Trigger Button
- Switching TCP/UDP Transmission Mode
- Using the System Utility
- Administrating the Camera
- Basic Operations of the Administrator Menu
- Configuring the System - System Menu
- Setting the Camera Image - Camera Menu
- Configuring the Network - Network Menu
- Setting the SSL function - SSL Menu
- Using the 802.1X Authentication Function - 802.1X Menu
- Setting the User - User Menu
- Setting the Security - Security Menu
- Saving the Camera Position and Action - Preset position Menu
- Sending an Image via E-mail - e-Mail (SMTP) Menu
- Sending Images to FTP Server - FTP Client Menu
- Setting the Operations from the Viewer - Trigger Menu
- Setting the Schedule - Schedule Menu
- Setting the Sensor input/Camera tampering detection/Motion detection - Event detection Menu
- Configuring the Viewer - Viewer Menu
- Others
- Using the SNC toolbox
- Starting SNC toolbox
- How to use SNC toolbox
- Registering in My device
- Changing the Device list display method
- Setting SNC toolbox options
- Using the Custom Homepage - Setting the customized homepage
- Using the Firmware Upgrade
- Using the Schedule Task
- Configuring the device setting
- Camera restart and initialization
- Assigning the IP Address to the Camera Using ARP Commands
- Using the SNMP
- Glossary
- Index
- Using the SNC toolbox
Administrating the Camera
Setting the SSL function — SSL Menu
53
To remove an installed CA
certificate
1
In Internet Explorer, click in the order Tool s,
Internet options, Content tab and Certificates.
The Certificates dialog appears.
2
Select the certificate you want to remove.
The CA certificate is usually stored in Trusted
Root Certification Authorities.
3
Click Remove.
Do you want to delete the certificate appears,
requesting confirmation.
4
Click Ye s.
The certificate will be removed.
There may be a case that a certificate cannot be
removed by the steps above due to the type of
certificate. Check the installation condition and
remove it following the steps below.
Note
You need to log in as Administrator to perform these
steps.
1
Open Run... of the Windows menu, then enter mmc
and click OK.
2
Select File in the Console 1 window and Add/
Remove Snap-in... (when Windows XP
Professional is used)
Add/Remove Snap-in... dialog appears.
3
Click Add to display Add Stand-alone Snap-in
dialog.
You need to follow this step if using Windows XP
Professional.
4
Select Certificates from the list, then click Add.
Certificate Snap-in is displayed.
5
Select Computer account as the certificate
administrated in this Snap-in, then click Next.
6
Select Local Computer as the computer
administrated in this Snap-in, then click Finish.
7
Close Add Standalone Snap-in (for Windows XP
Professional only) and Add/Remove Snap-in...
dialogs.
The items for administrating Certificates appears
in the Console Route window.
Confirm the relevant certificate, then remove it.