User Guide
Table Of Contents
- Table of Contents
- Overview
- Preparation
- Operating the Camera
- Administrator and User
- Logging in to the System
- Configuration of Main Viewer
- Main menu
- Control panel section
- Monitor image
- Plug-in free viewer
- Using SolidPTZ function
- Controlling via the control panel (Operation common to Area zoom mode and Vector dragging mode)
- Panning and tilting by clicking the monitor image (Area zoom mode only)
- Panning, tilting and zooming by specifying the area (Area zoom mode only)
- Panning and tilting by dragging the screen (Vector dragging mode only)
- Moving the camera to a preset position (Common operations in Area zoom and Vector dragging modes)
- Using pan/tilt/zoom operations with the displayed control bar (PTZ Control bar only)
- Controlling the Camera on a Full Image
- Using the Trigger Button
- Switching TCP/UDP Transmission Mode
- Using the System Utility
- Administrating the Camera
- Basic Operations of the Administrator Menu
- Configuring the System - System Menu
- Setting the Camera Image - Camera Menu
- Configuring the Network - Network Menu
- Setting the SSL function - SSL Menu
- Using the 802.1X Authentication Function - 802.1X Menu
- Setting the User - User Menu
- Setting the Security - Security Menu
- Saving the Camera Position and Action - Preset position Menu
- Sending an Image via E-mail - e-Mail (SMTP) Menu
- Sending Images to FTP Server - FTP Client Menu
- Setting the Operations from the Viewer - Trigger Menu
- Setting the Schedule - Schedule Menu
- Setting the Sensor input/Camera tampering detection/Motion detection - Event detection Menu
- Configuring the Viewer - Viewer Menu
- Others
- Using the SNC toolbox
- Starting SNC toolbox
- How to use SNC toolbox
- Registering in My device
- Changing the Device list display method
- Setting SNC toolbox options
- Using the Custom Homepage - Setting the customized homepage
- Using the Firmware Upgrade
- Using the Schedule Task
- Configuring the device setting
- Camera restart and initialization
- Assigning the IP Address to the Camera Using ARP Commands
- Using the SNMP
- Glossary
- Index
- Using the SNC toolbox
Others
Using the SNC toolbox
85
Tip
The Firmware Upgrade screen can also be displayed
using the following method:
•Select Firmware Upgrade from the Tools menu.
Device list
Select the device to upgrade.
A progress bar is displayed when updating is in process.
The status field shows current status.
Module list
To display the dialog, click the Browse button on the
right side of the model to update (listed in the module
list). Select the target SVU file from the dialog.
You can select one file for each model.
Updating
1
Set the order of devices perform update using Up
and Down.
2
Click Browse and select an upgrade file for each
model.
3
Select how many devices to upgrade in Paralleled
upgrade quantity.
4
To back up the camera setting, check Backup
device setting.
5
Click Start upgrading.
Upgrading starts.
Notes
• To stop upgrading, click Stop upgrading.
To protect some devices, during the process of
upgrading, upgrading cannot be canceled.
• Do not turn off the power until the device restarts after
upgrading.
Using the Schedule Task
You can specify the time or interval to change the Device
setting or perform Firmware upgrade.
Click Task to display the Task List, which shows a list
of scheduled executable tasks.
Task List
Displays the list of scheduled executable tasks.
Add
Displays the Task Wizard.
Modify
You can edit a task.
Delete
You can delete a task.
Start
Reserves a task.
Stop
You can cancel a task reservation.
Cancel
Closes the Task List.
Creating a task
1
Click Add.
***
***
Device list Module list