User Guide
Table Of Contents
- Table of Contents
- Overview
- Preparation
- Operating the Camera
- Administrator and User
- Logging in to the System
- Configuration of Main Viewer
- Main menu
- Control panel section
- Monitor image
- Plug-in free viewer
- Using SolidPTZ function
- Controlling via the control panel (Operation common to Area zoom mode and Vector dragging mode)
- Panning and tilting by clicking the monitor image (Area zoom mode only)
- Panning, tilting and zooming by specifying the area (Area zoom mode only)
- Panning and tilting by dragging the screen (Vector dragging mode only)
- Moving the camera to a preset position (Common operations in Area zoom and Vector dragging modes)
- Using pan/tilt/zoom operations with the displayed control bar (PTZ Control bar only)
- Controlling the Camera on a Full Image
- Using the Trigger Button
- Switching TCP/UDP Transmission Mode
- Using the System Utility
- Administrating the Camera
- Basic Operations of the Administrator Menu
- Configuring the System - System Menu
- Setting the Camera Image - Camera Menu
- Configuring the Network - Network Menu
- Setting the SSL function - SSL Menu
- Using the 802.1X Authentication Function - 802.1X Menu
- Setting the User - User Menu
- Setting the Security - Security Menu
- Saving the Camera Position and Action - Preset position Menu
- Sending an Image via E-mail - e-Mail (SMTP) Menu
- Sending Images to FTP Server - FTP Client Menu
- Setting the Operations from the Viewer - Trigger Menu
- Setting the Schedule - Schedule Menu
- Setting the Sensor input/Camera tampering detection/Motion detection - Event detection Menu
- Configuring the Viewer - Viewer Menu
- Others
- Using the SNC toolbox
- Starting SNC toolbox
- How to use SNC toolbox
- Registering in My device
- Changing the Device list display method
- Setting SNC toolbox options
- Using the Custom Homepage - Setting the customized homepage
- Using the Firmware Upgrade
- Using the Schedule Task
- Configuring the device setting
- Camera restart and initialization
- Assigning the IP Address to the Camera Using ARP Commands
- Using the SNMP
- Glossary
- Index
- Using the SNC toolbox
Others
Glossary
94
SNMP
A protocol for monitoring and managing network
devices.
SSL
Acronym for Secure Sockets Layer. This is a protocol
developed by Netscape Communications Corporation to
be used for communications of encrypted data on the
Internet.
Subnet mask
32-bit stream used to distinguish the subnet address
from an IP address.
TCP
Acronym for Transmission Control Protocol. A standard
protocol used for Internet connection. Compared with
the other protocol, UDP, TCP provides reliable
communication but communication speed is slower.
TKIP
Acronym for Temporal Key Integrity Protocol. This is
used in WPA encryption for a wireless LAN. TKIP
provides high security since it changes encryption keys
based on PSK during on-going communication.
UDP
Acronym for User Datagram Protocol. A standard
protocol used for Internet connection. Compared with
the other protocol, TCP, UDP can transmit data faster,
but reliable communication is not guaranteed.
Unicast
Transmission of data to specified equipment on a
network by specifying a single address.
WPA
Acronym for Wi-Fi Protected Access. This is an
encryption standard for a wireless LAN. It provides
higher security than the conventional WEP (Wired
Equivalent Privacy) standard. In WPA, TKIP is used for
the encryption method, and PSK and EAP are used for
the authentication protocol.
WPA2
Abbreviation for Wi-Fi Protected Access 2. WPA2 is a
standard with which AES (Advanced Encryption
Standard) is added to WPA.
802.1X
A standard that performs user authentication and
dynamic key generation and traffic on a LAN.