User Guide
Table Of Contents
- Table of Contents
- Overview
- Operating the Camera
- Administrator and User
- Logging in to System
- Configuration of Main Viewer
- Main menu
- Control panel section
- Monitor image
- Plug-in free viewer
- Using Solid PTZ function
- Controlling via the control panel (Operation common to Area zoom mode and Vector dragging mode)
- Panning and tilting by clicking the monitor image (Area zoom mode only)
- Panning, tilting and zooming by specifying the area (Area zoom mode only)
- Panning and tilting by dragging the screen (Vector dragging mode only)
- Switching Transmission Mode
- Administrating the Camera
- Basic Operations of the Administrator Menu
- Configuring the System - System Menu
- Setting the Camera Image and Audio - Video / Audio Menu
- Configuring the Network - Network Menu
- Setting the Security - Security Menu
- Setting the PTZ control - PTZ control Menu
- Setting the Sensor input/Camera tampering detection/Motion detection - Action input Menu
- Event condition Tab
- Sensor input Tab - Set the sensor input 1/2
- Camera tampering detection Tab - Set the camera tampering detection
- Motion detection Tab - Set the motion/VMF detection
- What is VMF
- Setting items for motion detection
- VMF settings
- Network disconnection Tab - Monitoring the connection of a specified IP address
- Setting the Action output - Action output Menu
- Setting the Schedule - Schedule Menu
- Others
Administrating the Camera
Setting the PTZ control — PTZ control Menu / Setting the Sensor input/Camera tampering detection/Motion detection — Action input Menu
26
Setting the PTZ control
— PTZ control Menu
When you click in the Administrator menu,
the PTZ control menu appears.
PTZ control Tab
Solid PTZ
Select On to enable the Solid PTZ function. You can set
Image 1, Image 2 and Image 3 separately.
Note
The Solid PTZ function is not available with Plug-in free
viewer.
OK/Cancel
See “Buttons common to every menu” on page 14.
Setting the Sensor input/
Camera tampering
detection/Motion
detection
— Action input Menu
When you click in the Administrator menu,
the Action input Menu appears. The Action input Menu
consists of the Event condition, Sensor input, Camera
tampering detection and Motion detection tabs.
Event condition Tab
Create event execute conditions for each action.
You can combine the following event execute conditions
together.
or: detect when either condition happens.
and: detect when both conditions happen within a
specified interval regardless of the sequence.
then: detect when each of the conditions happen within
a specified interval in sequence.
Interval
Specify the interval time used when condition is set to
and, then.
In the case the condition is set as 1 and 2, the system
sounds an alarm when either 1 or 2 happens, and the
other happens within the specified interval.
In the case the condition is set as 1 then 2, the system
sounds an alarm when 1 happens, and then 2 happens
within the specified interval.
If you select “or” condition, this setting will be ignored.
The maximum duration to be set is 7200 seconds.
You can select the alarm as follows:
Sensor input 1: The external sensor that is connected to
sensor input 1 of the camera I/O port.
Sensor input 2: The external sensor that is connected to
sensor input 2 of the camera I/O port.
Camera tampering detection: An alarm that is
triggered if the camera detects tampering, such as
direction shifting or spray.
VMF: The alarm detected by the VMF function.
Motion detection: The alarm detected by the motion
detection function.
Network disconnection: The alarm detected by
disconnection to a specific IP address.
PTZ control
Action input