User Guide

Administrating the Camera
Setting the Sensor input/Camera tampering detection/Motion detection — Action input Menu
27
Sensor input Tab — Set the sensor
input 1/2
Sensor input mode
Set the direction of the detected input signal to the
sensor input terminal of the camera.
Normally open: Detects the alarm when the sensor
input is short-circuited.
Normally closed: Detects the alarm when the sensor
input is open-circuited.
OK/Cancel
See “Buttons common to every menu” on page 14.
Camera tampering detection Tab —
Set the camera tampering detection
Note
Before using the tampering detection function, first
adjust the focus (SNC-VB600/VB600B/VB630) or the
focus/zoom (SNC-VM600/VM600B/VM601/
VM601B/VM630/VM631).
If you adjust focus/zoom with the tampering detection
function activated, detection may not be effective.
Enable
Select On to activate the function to detect camera
tampering, such as direction shifting or spray.
Detection status
Display the tampering detection state of the time when
Camera tampering detection tab is opened. To clear the
detection status, click Clear button.
OK/Cancel
See “Buttons common to every menu” on page 14.
Motion detection Tab — Set the
motion/VMF detection
Motion detection responds to moving objects in the
camera image and outputs an alarm. In VMF, an alarm
sounds when motion is detected under the motion
detection setting, entering or passing through a specified
area, or on an inspection line.
Notes
• For setting the privacy masking, set Image size1 in the
Video codec tab of the Video / Audio menu to the
maximum rate.
• Do not set the Solid PTZ function for Image 1.
What is VMF
VMF is a function for inspecting a motion detected in a
specified area, entering or passing through a specified
area, or on an inspection line.
The inspection methods; Intrusion/Passing, can be used,
and can be set to execute independently, or in
combination.
For example:
• An alarm sounds when an object enters areas A, B and
C.
• An alarm sounds when an object passes through area
A and enters area B.
• An alarm sounds when an object passes through areas
A and B, and enters area C.
• An alarm sounds when an object enters area A, and
passes through area B.
Intrusion
When a moving object exists in the designated area, an
alarm will sound. Video/audio recording can be
performed in synchronization with this alarm.
Passing
A passage line is determined, and when a moving object
passes the setting line, an alarm sounds.
Video/audio recording can be performed in
synchronization with this alarm.
Notes
• Before actual use, perform an operation test and
confirm that the motion detection function works
correctly.
• Even when privacy masking is used, the motion
detection function operates based on the images
before masking is processed.
• Before actual use, be sure to set Image size1 in the
Video codec tab of the Video / Audio menu to the
maximum rate.
• The authentication check dialog appears when you
open the motion detection setting screen. Enter the
administrator user ID and password.
When the Motion detection menu is
displayed for the first time
When you click Motion detection, “Security Warning”
is displayed.
When you click Yes , ActiveX control is installed and the
Motion detection menu is displayed.