Operating Instructions - (Multilingual)

17
Mount the Unit
3 Use the supplied control panel cable to
connect the SR-R4 and the unit.
4 Use the cable clamps as shown, to fix the
cable.
Notes
• Do not cross the cord below the clamps.
• Make sure that the bottom of the cord does not
extend beyond the bottom of the SR-R4.
• If the SR-R4 cannot be docked on the F65, refer
to the above and check the cord bundle again.
Note
Always turn off the power supply for the SR-R4 before
disconnecting the control panel cable and removing the
unit.
To remove the unit
Grasp the underside of the CP bracket and push it
in the B direction to release the lock. Then slide
the unit out.
Attach the unit to the F65, and connect the SR-R4
and the unit with the control panel cable.
1 Attach the outside bracket supplied
with the unit to the side of the F65, and
fasten using the 4 supplied screws (M3 ×
5).
There are 2 types of outside bracket. Attach
the larger outside bracket to an F65 with a
mechanical shutter or the smaller outside
bracket to an F65 without a mechanical
shutter.
Mount the Unit on the F65
Screws (M3 × 5)