Help Guide (Web manual)

Help Guide

MULTI CHANNEL AV RECEIVER

STR-DH590

The Control for HDMI function does not work properly.

Check the HDMI connection with the receiver (refer to the supplied Operating Instructions).

Enable the Control for HDMI function on the TV. For details, refer to the operating instructions of the TV.

Wait for a while, and then try again. If you unplug the receiver, it will take a while before the operation is completed.

Wait for 15 seconds or longer, and then try again.

If you unplug the HDMI cable or change the connection, repeat the procedures of “Preparing to use the “BRAVIA”

Sync function.”

Make sure your TV is connected to the HDMI TV OUT jack of the receiver.

Press AMP MENU, then set “<HDMI>” - “CTRL.HDMI” to “CTRL ON” on the display panel.

Make sure the connected device supports the Control for HDMI function.

Enable the Control for HDMI function on the connected device. For details, refer to the operating instructions of the

connected device.

The types and number of devices that can be controlled by the “BRAVIA” Sync feature are restricted by the HDMI

CEC standard as follows:

Recording devices (Blu-ray Disc recorders, DVD recorders, etc.): up to 3 devices

Playback devices (Blu-ray Disc players, DVD players, etc.): up to 3 devices

Tuner-related devices: up to 4 devices (one of them is used by this receiver)

Audio system (receiver/headphones): up to 1 device (used by this receiver)

116