Help Guide (Web manual)

Help Guide

MULTI CHANNEL AV RECEIVER

STR-DH590

Listening to sound from a BLUETOOTH device (Pairing operation)

Pairing is an operation where BLUETOOTH devices are registered to each other before connection. Once a pairing

operation is performed, it does not need to be performed again.

Canceling pairing operation

Select an input other than [BT].

Note

If the BLUETOOTH device does not support the AVRCP profile, you cannot perform playback or other operations on the receiver.

If a passkey is required on the display of the BLUETOOTH device in step 5, enter [0000]. The passkey may be called

“Passcode,” “PIN code,” “PIN number” or “Password.”

You can pair up to 10 BLUETOOTH devices. If a 11th BLUETOOTH device is paired, the least recently connected device will be

replaced by the new one.

Place the BLUETOOTH device within 1 meter (3.3 feet) of the receiver.

Press BLUETOOTH PAIRING to activate the pairing mode of the receiver.

“PAIRING” will appear on the display panel and the BLUETOOTH indicator on the front panel will flash quickly.

Perform pairing on the BLUETOOTH device to detect this receiver.

Perform this step within five minutes after step 2 is completed, or else pairing will be canceled. In this case, repeat

step 2.

For details, refer to the operating instructions of your BLUETOOTH device.

A list of detected devices may appear on the BLUETOOTH device display depending on the type of BLUETOOTH

device. This receiver is displayed as “STR-DH590”.

Select “STR-DH590” on the BLUETOOTH device display.

If “STR-DH590” is not displayed, repeat this process from step 1.

Make sure that the connection is completed and that the BLUETOOTH indicator has stopped flashing and

remains lit up.

The paired device name appears on the display panel.

Start playback on the BLUETOOTH device.

Adjust the volume.

Adjust the volume of the BLUETOOTH device first. If the volume level is still too low, adjust the volume level of the

receiver.