Operating Instructions

53
GB
Troubleshooting/Specifications
• Place the FM wire antenna (aerial) near a
window.
• Position the FM wire antenna (aerial) as
horizontally as possible.
You cannot tune to radio stations.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) if necessary.
• The signal of the stations is too weak
with automatic tuning. Use direct tuning.
• No stations have been preset or the
preset stations have been cleared (when
tuning by scanning preset stations is
used). Preset the stations.
• Press DISPLAY repeatedly so that the
frequency appears on the display panel.
Pairing cannot be done.
• Move the BLUETOOTH device closer to
the receiver.
• Pairing may not be possible if there are
other BLUETOOTH devices near the
receiver. In this case, turn off the other
BLUETOOTH devices.
• Correctly enter the same passkey that
was entered on the BLUETOOTH device.
Cannot make a BLUETOOTH
connection.
• The BLUETOOTH device you attempted to
connect does not support the A2DP
profile, and cannot be connected with
the receiver.
• Press BLUETOOTH to connect to the last
connected BLUETOOTH device.
• Turn on the BLUETOOTH function of the
BLUETOOTH device.
• Establish a connection from the
BLUETOOTH device.
• The pairing registration information has
been erased. Perform the pairing
operation again.
• While connected to a BLUETOOTH device,
this receiver cannot be detected.
• Erase the pairing registration information
of the BLUETOOTH device on the
BLUETOOTH device and perform the
pairing operation again.
The sound skips or fluctuates, or the
connection is lost.
• The receiver and the BLUETOOTH device
are too far apart.
• If there are obstructions between the
receiver and your BLUETOOTH device,
remove these or move the receiver
and/or device avoid them.
• If there is a device that generates
electromagnetic radiation, such as a
wireless LAN, other BLUETOOTH device,
or a microwave oven nearby, move it
away.
The sound of your BLUETOOTH
device cannot be heard on the
receiver.
• Turn up the volume on your BLUETOOTH
device first, and then adjust the volume
using  + on the remote control (or
MASTER VOLUME on the receiver).
Severe humming or noise.
• If there are obstructions between the
receiver and your BLUETOOTH device,
remove them or move the receiver
and/or device avoid them.
• If there is a device that generates
electromagnetic radiation, such as a
wireless LAN, other BLUETOOTH device,
or a microwave oven nearby, move it
away.
• Turn down the volume of the connected
BLUETOOTH device.
The remote control does not
function.
• Point the remote control at the remote
control sensor on the receiver.
• Remove any obstructions between the
remote control and the receiver.
BLUETOOTH device
Remote control