Operating Instructions

35
GB
D:\NORM'S JOB\SONY HA\SO160039\STR-DN1070 (PMRF 05)\4583748161_GB\030CON.fm masterpage: Right
STR-DN1070
4-583-748-16(1)
Preparation
By performing Easy Setup, you can complete:
1: Selecting the language
2: Setting the speakers
Check your speaker system and perform
Auto Calibration according to the
configuration and arrangement of your
speaker system.
3: Performing Internet settings
Select the network connection method and
configure settings to connect the receiver
to the network.
Before you perform Auto
Calibration
 Disconnect the headphones.
 Remove any obstacles between the
calibration microphone and the speakers.
 Auto Calibration is not available when
[Bluetooth Mode] is set to [Transmitter].
 For accurate measurement, make sure the
environment is quiet and free from noise.
 Set the speaker output to a setting other
than “SPK OFF”. See “Selecting the front
speakers” (page 36).
 Confirm the active subwoofer setup
 When a subwoofer is connected, turn on
the subwoofer and turn up the volume
prior to activating the subwoofer. Turn
the LEVEL to just before the mid-point.
 If you connect a subwoofer with a
crossover frequency function, set the
value to maximum.
 If you connect a subwoofer with an auto
standby function, set it to off
(deactivated).
Depending on the characteristics of the
subwoofer you are using, the setup distance value
may be different from the actual position.
 Connect the supplied calibration
microphone to CALIBRATION MIC jack. Set
up the calibration microphone at your
listening position.
The speakers emit very loud sound during the
calibration and the volume cannot be adjusted.
Be considerate of your neighbors and any
children who are present.
If the muting function has been activated before
you perform Auto Calibration, the muting
function will shut off automatically.
It may not be possible to take the correct
measurements or to perform Auto Calibration at
all if special speakers such as dipole speakers are
used.
If the measurement fails, follow the message,
then select [Retry]. For details on the error code
and warning message, see “List of messages
after Auto Calibration measurements” (page 50).
To cancel Auto Calibration
The Auto Calibration function will be canceled
when you perform the following during the
measurement process:
 Press  (power).
 Press the input buttons on the remote
control or turn the INPUT SELECTOR on the
receiver.
 Press .
 Press SPEAKERS on the receiver.
 Change the volume level.
 Connect the headphones.
What you can do with Easy Setup
Auto Calibration
Note
Note
Calibration
microphone