Operating Instructions

38
GB
D:\NORM'S JOB\SONY HA\SO160039\STR-DN1070 (PMRF 05)\4583748161_GB\040PLA.fm masterpage: Left
STR-DN1070
4-583-748-16(1)
If you want to listen to the same sound as main
zone in other zone, select [SOURCE].
7 Start playback on the selected
input device.
8 Select [Zone2 Volume] or
[Zone3 Volume], then adjust
the volume.
You can also turn MASTER VOLUME on
the receiver while “2. xxxx”* or “3. xxxx”*
appears on the display panel.
* “xxxx” is the input name.
You can operate the receiver without pointing the
remote control toward the receiver if you connect an
IR Blaster (not supplied) to the IR REMOTE jack.
To exit zone operation
Set [Zone2 Power] or [Zone3 Power] to [Off] in
step 5.
1 Connect another amplifier
located in Zone 2 (page 31).
2 Turn on the receiver in main
zone and the amplifier in
Zone 2.
3 Set the volume control for
Zone 2.
Press HOME, then select [Setup] – [Zone
Settings] – [Zone2 Line Out] – [Variable]
or [Fixed].
 [Variable]: The volume for the ZONE 2
OUT jacks can be changed. Select this
when using another amplifier that does
not have volume control.
 [Fixed]: The volume for the ZONE 2 OUT
jacks is fixed. Select this when using
another amplifier with variable volume
control.
4 Press HOME, then select [Zone
Controls] – [Zone2] – [Zone2
Power] – [On].
You can also press ZONE SELECT on the
receiver repeatedly to select “ZONE 2”,
then press ZONE POWER on the receiver.
5 Select [Zone2 Input], then
select the source signals you
want to output.
You can also turn INPUT SELECTOR on the
receiver while “2. xxxx”* appears on the
display panel.
* “xxxx” is the input name.
If you want to listen to the same sound as main
zone in other zone, select [SOURCE].
6 Start playback on the selected
input device.
7 Adjust the volume.
Adjust the volume using the amplifier in
Zone 2.
If you set [Zone2 Line Out] to [Variable] in
step 3 above, select [Zone2 Volume]
then adjust the volume. You can also
turn MASTER VOLUME on the receiver
while “2. xxxx”* appears on the display
panel.
* “xxxx” is the input name.
You can operate the receiver without pointing the
remote control toward the receiver if you connect an
IR Blaster (not supplied) to the IR REMOTE jack.
To exit zone operation
Set [Zone2 Power] to [Off] in step 4.
Tip
Tip
Enjoying sound from speakers
located in other rooms using
another amplifier (Zone 2)
Tip
Tip