Operating Instructions

51
GB
D:\NORM'S JOB\SONY HA\SO160039\STR-DN1070 (PMRF 05)\4583748161_GB\050ADD.fm masterpage: Right
STR-DN1070
4-583-748-16(1)
Additional Information
Warning 41, Warning 42
 The input from the microphone is too large.
 The distance between the speaker and the
microphone may be too short. Set them
further apart and perform the
measurement again.
Warning 43
 The distance and phase of a subwoofer
cannot be detected. This may be caused by
noise. Try performing the measurement in a
quiet environment.
Precautions
On safety
Should any solid object or liquid fall into the
cabinet, unplug the receiver and have it
checked by qualified personnel before
operating it any further.
On power sources
 Before operating the receiver, check that
the operating voltage is identical with your
local power supply.
The operating voltage is indicated on the
nameplate on the back of the receiver.
 If you are not going to use the receiver for a
long time, be sure to disconnect the
receiver from the wall outlet. To disconnect
the AC power cord (mains lead), grasp the
plug itself; never pull the cord.
 The AC power cord (mains lead) must be
changed only at a qualified service shop.
On heat buildup
Although the receiver heats up during
operation, this is not a malfunction. If you
continuously use this receiver at a large
volume, the cabinet temperature of the top,
side and bottom rises considerably. To avoid
burning yourself, do not touch the cabinet.
On placement
 Place the receiver in a location with
adequate ventilation to prevent heat
buildup and prolong the life of the receiver.
 Do not place the receiver near heat sources,
or in a place subject to direct sunlight,
excessive dust, or mechanical shock.
 Do not place anything on top of the cabinet
that might block the ventilation holes and
cause malfunctions.
 Do not place the receiver near device such
as a TV, VCR, or tape deck. (If the receiver is
being used in combination with a TV, VCR,
or tape deck, and is placed too close to that
device, noise may result, and picture quality
may suffer. This is especially likely when
using an indoor antenna (aerial).)
 Use caution when placing the receiver on
surfaces that have been specially treated
(with wax, oil, polish, etc.) as staining or
discoloration of the surface may result.
On operation
Before connecting other device, be sure to
turn off and unplug the receiver.
On cleaning
Clean the cabinet, panel, and controls with a
soft cloth slightly moistened with a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder, or solvent,
such as alcohol or benzine.
Supported BLUETOOTH version
and profiles
Profile refers to a standard set of functions for
various BLUETOOTH product features. See
“BLUETOOTH section” in “Specifications”
(page 53) for the BLUETOOTH version and
profiles supported by this receiver.
Effective communication range
BLUETOOTH devices should be used within
approximately 10 meters (33 feet)
(unobstructed distance) of each other. The
effective communication range may become
shorter under the following conditions.
On BLUETOOTH communication