Help Guide (Web manual)

SP A :
Speakers connected to the SPEAKERS FRONT A terminals.
SP B (*):
Speakers connected to the SPEAKERS SURROUND BACK/HEIGHT (FRONT B/BI-AMP/ZONE 2) terminals.
SP AB (*):
Speakers connected to both the SPEAKERS FRONT A and SPEAKERS SURROUND BACK/HEIGHT (FRONT
B/BI-AMP/ZONE 2) terminals (parallel connection).
(None):
[SPEAKERS OFF] appears on the display panel. No audio signals are output from any speaker terminals, or
the PRE OUT jacks.
[106] Adjusting Settings
Speaker Setup
5. Performing Auto Calibration
You can perform automatic calibration from your listening position.
Calibration Matching
When Auto Calibration is executed, this function works automatically, matching the distance and level of the
right and left speakers. You can set this function only after the D.C.A.C. measurement process has been
completed and the results of the D.C.A.C. measurement are saved. The setting is valid until you change it.
To select [SP B] or [SP AB], set the assignment for the SPEAKERS SURROUND BACK/HEIGHT (FRONT B/BI-AMP/ZONE 2) terminals to
[Front B] by using [SB Speaker Assign] in the [Speaker Setup] menu.
*
Select [Setup] - [Speaker Setup] from the home menu.
1
Select [Auto Calibration].
2
Follow the instructions on the TV screen, then press
to select [Start].
The measurement starts in 5 seconds.
The measurement process will take approximately 30 seconds with a test tone.
When the measurement ends, a beep sounds and the screen switches.
3
Select the item you want.
Save: Saves the measurement results and exits the setting process.
Retry: Performs the Auto Calibration again.
Discard: Exits the setting process without saving the measurement results.
For details on the measurement results, see “
6. Checking Auto Calibration results.”
4
Save the measurement results.
Select [Save] in step 4.
5