Help Guide (Web manual)

Note
If an error code or warning message appears on the screen in step 3, see “List of messages after Auto Calibration
measurements.”
Hint
You can also perform automatic calibration by pressing the AUTO CAL button on the remote control. If you use the AUTO
CAL button, the following restrictions apply to the operation:
Prior settings relating to the Auto Calibration will be skipped.
You can only use the display panel for the operation.
The Auto Calibration function will be canceled if you perform the following during the measurement process:
Turn the receiver on or off.
Press the input buttons on the remote control or on the receiver.
Press
.
Press SPEAKERS on the receiver.
Press HDMI OUTPUT.
Press AMP MENU.
Press HOME.
Press AUTO CAL.
Change the volume level.
[107] Adjusting Settings Speaker Setup
6. Checking Auto Calibration results
To check error codes or warning messages received in [Auto Calibration], proceed with the following steps:
If an error code appears
Check the error and perform Auto Calibration again.
Select [Retry].
1
Follow the instructions on the TV screen and then press
to select [Start].
The measurement starts in 5 seconds.
The measurement process will take approximately 30 seconds with a test tone.
When the measurement ends, a beep sounds and the screen switches.
2
Select the item you want.
Save: Saves the measurement results and exits the setting process.
Retry: Performs the Auto Calibration again.
Discard: Exits the setting process without saving the measurement results.
3
Save the measurement results.
4