Help Guide (Web manual)

If a warning message appears

Check the warning message and select [OK]. For details on the warning messages, see “List of messages after

Auto Calibration measurements.”

Hint

The measurement results may vary depending on the position of the subwoofer. However, continuing to use the receiver

with that value does not cause problems.

[108] Adjusting Settings Speaker Setup

Calibrating the phase characteristics of the speakers

(Automatic Phase Matching)

You can set the A.P.M. (Automatic Phase Matching) function in the D.C.A.C. (Digital Cinema Auto Calibration).

This calibrates the phase characteristics of the speakers for well-coordinated surround sound.

Note

This function does not work in the following cases:

[Direct] is being used and an analog input is selected.

[Auto Calibration] has not been performed.

The receiver may play signals at a lower sampling frequency than the actual sampling frequency of the input signals,

depending on the audio format.

[109] Adjusting Settings Speaker Setup

Select [Save] in step 3.

Select [Setup] - [Speaker Setup] from the home menu.

Select [Automatic Phase Matching].

Select the setting you want.

Auto: Switches the A.P.M. function on or off automatically.

Off