Help Guide (Web manual)

Selecting the Auto Calibration type (Calibration Type)

You can select a calibration type after you have performed the Auto Calibration and saved the settings.

Note

This function does not work when [Direct] is being used and an analog input is selected.

The receiver may play signals at a lower sampling frequency than the actual sampling frequency of the input signals,

depending on the audio format.

[110] Adjusting Settings Speaker Setup

Selecting the speaker pattern (Speaker Pattern)

You can select the speaker pattern according to the speaker system which you are using.

[111] Adjusting Settings

Speaker Setup

Select [Setup] - [Speaker Setup] from the home menu.

Select [Calibration Type].

Select the setting you want.

Full Flat: Makes the measurement of frequency from each speaker flat.

Engineer: Sets to “the Sony listening room standard” frequency characteristics.

Front Reference: Adjusts the characteristics of all of the speakers to match the characteristics of the

front speaker.

Off

Select [Setup] - [Speaker Setup] from the home menu.

Select [Speaker Pattern].

Select the speaker pattern you want.