Help Guide (Web manual)

Checking the speaker position and the corresponding

speaker terminals (Speaker Connections)

This function lets you know the position of the speaker you select and the corresponding speaker terminals on

the receiver to which the speaker should be connected.

[112] Adjusting Settings

Speaker Setup

Assigning the surround back speaker terminals (SB Speaker

Assign)

You can set the assignment for the SPEAKERS SURROUND BACK/HEIGHT (FRONT B/BI-AMP/ZONE 2) terminals.

Note

When you change the connection from a bi-amplifier or speakers front B to surround back speakers connection, set the

[SB Speaker Assign] to [Off], then set up the speakers again.

You can only set [SB Speaker Assign] if one of the following speaker patterns that do not use the SPEAKERS SURROUND

BACK/HEIGHT (FRONT B/BI-AMP/ZONE 2) terminals is selected:

STR-ZA3100ES/STR-ZA2100ES: 2.0, 2.0.2, 2.1, 2.1.2, 3.0, 3.0.2, 3.1, 3.1.2, 4.0, 4.0.2, 4.1, 4.1.2, 5.0, 5.0.2, 5.1 or

Select [Setup] - [Speaker Setup] from the home menu.

Select [Speaker Connections].

Select the speaker you want from the list on the right side of the screen

The position of the speaker and the corresponding terminals on the receiver to which the speaker should be

connected are shown on the screen.

Select [Setup] - [Speaker Setup] from the home menu.

Select [SB Speaker Assign].

Select any of the following settings.

Zone2: When using Zone 2 connection.

Bi-Amp: When using the bi-amplifier connection.

Front B: When using the front B speaker connection.

Off: When none of the connections above are used.