Help Guide (Web manual)

Hint
You can set a test tone by pressing the TEST TONE button on the remote control. In this case, you can only use the
display panel for the operation.
To adjust the level of all speakers at the same time, press
+/–. You can also use MASTER VOLUME on the receiver.
The adjusted value is shown on the TV screen during adjustment.
[117] Adjusting Settings Speaker Setup
Setting the crossover frequency of the speakers (Crossover
Frequency)
You can set the bass crossover frequency of speakers for which the speaker size has been set to [Small] in the
[Speaker Setup] menu. A measured speaker crossover frequency is set for each speaker after the Auto
Calibration is performed.
Select [Setup] - [Speaker Setup] from the home menu.
1
Select [Test Tone].
2
Select the setting you want.
Off
Auto: The test tone is output from each speaker in sequence.
Front L, Center, Front R, Surround R, Surround L, Sur Back (*1), Sur Back L, Sur Back R,
Height1 L (*2), Height1 R (*2), Height2 L (*2), Height2 R (*2), Height L (*3), Height R (*3),
Subwoofer: You can select which speakers will output the test tone.
3
[Sur Back] appears when only one surround back speaker is connected.
*1
for STR-ZA3100ES/STR-ZA2100ES
*2
for STR-ZA1100ES
*3
Adjust the speaker level.
4
Select [Setup] - [Speaker Setup] from the home menu.
1
Select [Crossover Frequency].
2
Select the speaker for which you want to adjust the crossover frequency on the screen.
3