Help Guide (Web manual)

Viewing information on the display panel

The display panel provides various information on the status of the receiver, such as the sound field.

Note

Characters or marks in some languages may not be displayed.

[173] Adjusting Settings

Reverting to the factory default settings

You can clear all memorized settings and restore the receiver to the factory default settings by the following

procedure. This procedure can also be used to initialize the receiver before you use it for the first time.

Be sure to use the buttons on the receiver to perform this operation.

Note

Select the input for which you want to check information.

Press DISPLAY repeatedly.

The default input name or the input name you have set is displayed on the upper line of the display panel.

The lower line of the display panel will change sequentially as follows each time you press DISPLAY:

currently applied sound field (*1)→stream information (*2)→default input name (*3).

When listening to FM or AM radio

The band, preset number, and preset station name (*4) or frequency are displayed on the upper line of the

display panel.

The currently applied sound field is displayed on the lower line of the display panel.

[PURE DIRECT] appears on the display panel when the Pure Direct function is activated.

Stream Information is not displayed when no signals can be found for the selected input.

Appears only when you have set an arbitrary input name.

Appears only when you have set an arbitrary preset station name. In this case, the preset station name and frequency are displayed

alternately each time you press DISPLAY.

Turn off the receiver.

Hold down

(power) on the receiver for 5 seconds.

[MEMORY CLEARING] appears on the display panel for a while, then changes to [MEMORY CLEARED!].