Help Guide (Web manual)

disconnected by pulling on them slightly.
The speaker cables may have short-circuited.
[203] Troubleshooting
Sound
A test tone is output from a different speaker than the
speaker displayed on the TV screen.
The speaker pattern setup is incorrect. Make sure that the speaker connections and the speaker pattern
match correctly.
[204] Troubleshooting
Sound
No sound is output from the TV when the receiver is in
standby mode.
When the receiver enters standby mode, the image from the last HDMI device selected before you turned off
the receiver is displayed. If you are enjoying content from another device, play the content on the device and
perform the One-Touch Play operation, or turn on the receiver to select the HDMI device from which you
want to enjoy content.
Make sure [Standby Through] is set to [Auto] or [On] in the [HDMI Setup] menu.
[205] Troubleshooting
Tuner
The FM reception is poor.
Extend and adjust the position of the FM wire antenna (aerial) to a place where the reception conditions are
good.
Place the FM wire antenna (aerial) near a window.
[206] Troubleshooting
Tuner
The FM stereo reception is poor.
Set the FM station receiving mode to the monaural mode.