Help Guide (Web manual)

Monaural audio cable (not supplied)
Speaker cable (not supplied)
After you have made the Zone 2 speaker connection, set [SB Speaker Assign] to [Zone2] in the [Speaker Setup]
menu.
Note
After you have installed and connected your speakers, set the speaker pattern to [5.1] using [Speaker Pattern] in the
[Speaker Setup] menu.
You can only set [SB Speaker Assign] if a speaker pattern in which speakers are not connected to the SPEAKERS
SURROUND BACK/HEIGHT(FRONT B/BI-AMP/ZONE 2) terminals is selected.
Connect speaker cables properly with the polarities (+/–) matched between the speaker cables and the SPEAKERS
terminals.
[24] Preparation 2. Connecting speakers
Connecting 5.1.2-channel speaker system with bi-amplifier
connection (for STR-ZA3100ES/STR-ZA2100ES)
You can enhance the sound quality of the front speakers by separately connecting the built-in amplifiers to
tweeters and woofers in a bi-amplifier configuration.
If a speaker pattern in which speakers are not connected to the SPEAKERS SURROUND BACK/HEIGHT(FRONT
B/BI-AMP/ZONE 2) terminals is selected, you can connect front speakers to those terminals for bi-amplifier
connection. Connect each speaker as illustrated below.
Before connecting cables, be sure to disconnect the AC power cord (mains lead).
For details on how to connect speaker cables to the receiver, see “
How to connect speaker cables.”
Connecting front speakers with bi-amplifier connection