Help Guide (Web manual)

[27] Preparation 2. Connecting speakers
Speaker patterns and terminals to be connected (for STR-
ZA1100ES)
When you connect speakers to the receiver, refer to the following table.
You can use the following table to confirm the speaker patterns supported by the receiver as well as the speaker
terminals to which the speakers of each speaker pattern are to be connected.
When playing back DTS content, select a speaker pattern which supports DTS playback (*), indicated with ♦
below. If you select other speaker patterns, the sound may not be output from some speakers.
To set the speaker pattern, select [Setup] - [Speaker Setup] - [Speaker Pattern] from the home menu.
The abbreviations and symbol used in the list are as follows.
FH: Front high speakers
TM: Top middle speakers
FD: Front Dolby Atmos enabled speakers
SRD: Surround Dolby Atmos enabled speakers
SB: SPEAKERS SURROUND BACK/HEIGHT (FRONT B/BI-AMP/ZONE 2) terminals
What the numbers in the speaker pattern indicate:
Number of speakers located at listener’s level
Number of subwoofers
Number of height or overhead (top) speakers
7.1.2
(TM)
○ ○ ○ ○ ○ (TM) ○ Not Available
7.1.2
(FD)
○ ○ ○ ○ ○ (FD) ○ Not Available
7.1.2
(SRD)
○ ○ ○ ○ ○ (SRD) ○ Not Available
7.1.2
(SBD)
○ ○ ○ ○ ○ (SBD) ○ Not Available
Due to the receiver’s system limitations
*
Speaker
pattern
SPEAKERS terminals
PRE OUT
jacks
Zone 2
connection/
Front B
speaker
connection/
Bi-amplifier
connection
FRONT
A
CENTER SURROUND
SURROUND
BACK/HEIGHT (FRONT
B/BI-AMP/ZONE 2)
(L/R)
SUBWOOFER
2.0 ♦ ○ - - - - SB
2.0.2
(TM)
○ - - ○ (TM) - Not Available