Help Guide (Web manual)

Note
After you turn off the receiver, [STANDBY] flashes on the display panel. Do not disconnect the AC power cord (mains
lead) while [STANDBY] is flashing. This may cause a malfunction.
[46] Preparation 6. Turning on the receiver/preparing the remote control
Notes on installing the receiver
Do not install the receiver in a confined space, such as a bookcase.
Sufficient space around the receiver is needed to release heat. When placing the receiver in a rack, leave
more than 44.45 mm (1.75 in) space above the receiver, and more than 44.45 mm (1.75 in) space along the
sides of the receiver. The rack behind the receiver should be open. If you place the receiver with its back
against the wall, leave more than 88.9 mm (3.5 in) space between the receiver and the wall.
Make sure to use a “WS-RE1” dedicated rack mount kit for this receiver when mounting the receiver on a
rack mount.
Place the receiver in a location with adequate ventilation to prevent heat buildup and prolong the life of the
receiver.
Do not place the receiver near heat sources, or in a place subject to direct sunlight, excessive dust, or
mechanical shock.
Do not place anything on top of the cabinet that might block the ventilation holes and cause malfunctions.
Magnets are attached to both the front panel and front cover. Do not place cards with magnetic stripes, such
as bank cards or ID passes, near the receiver. These cards may become unusable due to the effects of the
magnets on the receiver.
[47] Preparation
7. Setting up the receiver using Easy Setup
Setting up the receiver using the Easy Setup
When you turn on the receiver for the first time or after the receiver is initialized, the Easy Setup screen appears
on the TV screen. You can set up the following settings for the receiver by following the instructions on the Easy
Setup screen.
Auto Calibration
Check your speaker system and perform automatic calibration according to the configuration and
arrangement of your speaker system.
Internet Setup
Configure settings to connect the receiver to the network.
Note
Switch the input of the TV to the input to which the receiver is connected to use this function.
You can also turn on the receiver using MAIN (power) on the remote control. To turn off the receiver,
press MAIN (power) again.