Help Guide (Web manual)

The indicators on the display panel shows which set of terminals are selected.
SP A :
Speakers connected to the SPEAKERS FRONT A terminals.
SP B (*):
Speakers connected to the SPEAKERS SURROUND BACK/HEIGHT (FRONT B/BI-AMP/ZONE 2) terminals.
SP AB (*):
Speakers connected to both the SPEAKERS FRONT A and SPEAKERS SURROUND BACK/HEIGHT (FRONT
B/BI-AMP/ZONE 2) terminals (parallel connection).
(None):
[SPEAKERS OFF] appears on the display panel. No audio signals are output from any speaker terminals, or
the PRE OUT jacks.
[52] Preparation
Performing Auto Calibration
5. Performing Auto Calibration
You can perform automatic calibration from your listening position.
To select [SP B] or [SP AB], set the assignment for the SPEAKERS SURROUND BACK/HEIGHT (FRONT B/BI-AMP/ZONE 2) terminals to
[Front B] by using [SB Speaker Assign] in the [Speaker Setup] menu.
*
Select [Setup] - [Speaker Setup] from the home menu.
1
Select [Auto Calibration].
2
Follow the instructions on the TV screen, then press
to select [Start].
The measurement starts in 5 seconds.
The measurement process will take approximately 30 seconds with a test tone.
When the measurement ends, a beep sounds and the screen switches.
3
Select the item you want.
Save: Saves the measurement results and exits the setting process.
Retry: Performs the Auto Calibration again.
Discard: Exits the setting process without saving the measurement results.
4