Help Guide (Web manual)

Calibration Matching

When Auto Calibration is executed, this function works automatically, matching the distance and level of the

right and left speakers. You can set this function only after the D.C.A.C. measurement process has been

completed and the results of the D.C.A.C. measurement are saved. The setting is valid until you change it.

Note

If an error code or warning message appears on the screen in step 3, see “List of messages after Auto Calibration

measurements.”

Hint

You can also perform automatic calibration by pressing the AUTO CAL button on the remote control. If you use the AUTO

CAL button, the following restrictions apply to the operation:

Prior settings relating to the Auto Calibration will be skipped.

You can only use the display panel for the operation.

The Auto Calibration function will be canceled if you perform the following during the measurement process:

Turn the receiver on or off.

Press the input buttons on the remote control or on the receiver.

Press

Press SPEAKERS on the receiver.

Press HDMI OUTPUT.

Press AMP MENU.

Press HOME.

Press AUTO CAL.

Change the volume level.

[53] Preparation Performing Auto Calibration

6. Checking Auto Calibration results

To check error codes or warning messages received in [Auto Calibration], proceed with the following steps:

If an error code appears

Check the error and perform Auto Calibration again.

For details on the measurement results, see “

6. Checking Auto Calibration results.”

Save the measurement results.

Select [Save] in step 4.

Select [Retry].

Follow the instructions on the TV screen and then press

to select [Start].