Help Guide (Web manual)

If a warning message appears
Check the warning message and select [OK]. For details on the warning messages, see “List of messages after
Auto Calibration measurements.”
Hint
The measurement results may vary depending on the position of the subwoofer. However, continuing to use the receiver
with that value does not cause problems.
[54] Enjoying Video and Sound Playing AV devices
Using the menu on the TV screen
You can display the menu of the receiver on the TV screen (*).
The measurement starts in 5 seconds.
The measurement process will take approximately 30 seconds with a test tone.
When the measurement ends, a beep sounds and the screen switches.
Select the item you want.
Save: Saves the measurement results and exits the setting process.
Retry: Performs the Auto Calibration again.
Discard: Exits the setting process without saving the measurement results.
3
Save the measurement results.
Select [Save] in step 3.
4
When you want to display the menu on the TV screen connected to the HDMI OUT B (ZONE 2) jack, set [HDMI Out B Mode] to
[Main].
*
Switch the input of the TV to the input to which the receiver is connected.
1
Press HOME to display the home menu on the TV screen.
2