Help Guide (Web manual)

Note

You can only set [SB Speaker Assign] if a speaker pattern that does not use the SPEAKERS SURROUND BACK/HEIGHT

(FRONT B/BI-AMP/ZONE 2) terminals is selected.

[75] Using the Multi-Zone Features Enjoying sound from speakers located in another room (Zone 2)

Enjoying sound in Zone 2

You can enjoy sound from the receiver in Zone 2 by the following procedure.

Hint

You can also activate Zone 2 by pressing ZONE2 (power) on the remote control, or by pressing ZONE2 on the

receiver.

After Zone 2 is activated, you can also select source signals using the input buttons on the receiver or adjust the volume

level using MASTER VOLUME on the receiver while the display panel of the receiver is in one of the following states:

While [ZONE2 POWER ON] is displayed just after Zone 2 has been activated.

While displaying [ZONE2 INPUT xxxx (input name)] by pressing ZONE CONTROL on the receiver.

Set a speaker pattern in which speakers are not connected to the SPEAKERS SURROUND

BACK/HEIGHT (FRONT B/BI-AMP/ZONE 2) terminals.

Assign the speaker terminals for Zone 2 in the following way:

Assigning the surround back speaker terminals (SB Speaker Assign)

Select [Zone Controls] - [Zone2 Power] - [On] from the home menu.

Zone 2 is activated.

Select the source signals you want to output in [Zone2 Input].

Select [SOURCE] if you want to listen to the same sound as main zone in Zone 2.

Start playback on the device connected appropriate input.

Adjust to a suitable volume level in [Zone2 Volume].