Owner's Manual

22
GB
D:\NORM'S JOB\SONY HA\SO17_STR-DH190\STR-DH190\4726907111_GB\050PLA.fm masterpage: Left
STR-DH190
4-726-907-11(1)
Pairing is an operation in which
BLUETOOTH devices are registered to each
other before connection. Follow the steps
below to pair the BLUETOOTH device and
the receiver. Once the BLUETOOTH devices
are paired, there is no need to pair them
again. When the pairing is complete,
proceed to “Listening to sound on a paired
BLUETOOTH device” (page 22).
1 Place the BLUETOOTH device
within 1 meter (3.3 feet) of
the receiver.
2 Press BLUETOOTH PAIRING.
“PAIRING” flashes on the display
panel. Perform step 3 within five
minutes, otherwise pairing will be
canceled. If pairing is canceled, repeat
this step.
3 Perform pairing on the
BLUETOOTH device to detect
the receiver.
For details, refer to the operating
instructions of your BLUETOOTH
device.
A list of detected devices may appear
on the BLUETOOTH device display
depending on the type of BLUETOOTH
device. The receiver is displayed as
“STR-DH190”.
4 Select “STR-DH190” on the
BLUETOOTH device display.
If “STR-DH190” is not displayed, repeat
this process from step 1.
When the BLUETOOTH connection is
established, the paired device name
appears on the display panel.
5 Start playback on the
BLUETOOTH device.
6 Adjust the volume.
Adjust the volume of the BLUETOOTH
device first. If the volume level is still
too low, press  +/– to adjust the
volume level of the receiver.
To cancel pairing operation
Pairing operation will be canceled when
you switch the input.
• Some applications of BLUETOOTH device cannot
be controlled from the receiver.
• If a passkey is required on the display of the
BLUETOOTH device in step 4, enter “0000”. The
passkey may be called “Passcode”, “PIN code”,
“PIN number” or “Password”.
• You can pair up to ten BLUETOOTH devices. If an
11th BLUETOOTH device is paired, the least
recently connected device will be replaced by
the new one.
• You can operate a BLUETOOTH device using
/ (fast rewind/fast forward), /
(previous/next),  (play/pause),  (stop).
•If you press  in “BLUETOOTH” input when no
BLUETOOTH device is connected, the receiver
automatically connects to the last connected
BLUETOOTH device.
1 Turn on the BLUETOOTH
function on the BLUETOOTH
device.
2 Press BLUETOOTH.
The receiver connects to the last
connected BLUETOOTH device and the
device name appears on the display
panel.
3 Start playback on the
BLUETOOTH device.
Registering BLUETOOTH
devices to the receiver (Pairing
operation)
Note
Tip
Listening to sound on a paired
BLUETOOTH device