User Guide

SVR-S500
2-689-634-11(1)
12
D:\DVR project\Instruction
manual\DTP\2689634111\GB04BAS-CEK.fm
master page=left
2 With the TV [/1 button pressed down,
enter the TV’s manufacturer code using the
number buttons.
For instance, to enter “09,” press “0” then “9.”
After you enter the last number, release the
TV [/1 button.
Code numbers of controllable TVs
If more than one code number is listed, try
entering them one at a time until you find the
one that works with your TV.
The remote performs the following:
To operate the TV/VIDEO button
The TV/VIDEO button switches the input source
on your TV. Point your remote at the TV when
using this button.
When you connect the recorder to the TV via the
SCART jacks, the input source for the TV is set to
the recorder automatically when you turn on the
recorder. To watch another source, press the TV/
VIDEO button to switch the TV’s input source.
If the supplied remote interferes with your other
Sony Hard Disk recorder, set the command mode
number for this recorder and the supplied remote
to one that differs from the other Sony Hard Disk
recorder after you have completed “Step 6: Auto
Tuning (Full Channel Scan)” (page 13).
The default command mode setting for this
recorder and the supplied remote is HDD 1.
1 Check that “Step 6: Auto Tuning (Full
Channel Scan)” on page 13 has been
finished.
2 Press SYSTEM MENU.
The System Menu appears.
3 Select “SETUP,” and press ENTER.
4 Select “Features,” and press ENTER.
Manufacturer Code number
Sony 01 (default)
Hitachi 24
JVC 33
Panasonic 17, 49
Philips 06, 08
Samsung 71
Sanyo 25
Thomson 43
Toshiba 38
Buttons Operations
TV [/1 Turns your TV on or off
TV VOL +/– Adjusts the volume of
your TV
TV PROG +/– Selects the programme
position on your TV
TV/VIDEO Switches your TV’s
input source
If you have more than one Sony
Hard Disk Recorder
SYSTEM
MENU
RETURN
</M/m/,,
ENTER
Number
buttons
SETUP
Setup Options
DTV Settings
Options
Features
Technical infos
12:15