User's Manual

9
Settings
Setting the Receive Channel
For details about the channel groups and channels that can
be selected, refer to the “Frequency List” on the
CD-ROM.
To prevent interference and noise, beware of the
following.
• Do not use multiple transmitters that have been set to
the same channel at the same time.
• When using two or more channels at the same time,
always configure different channels within the same
group.
• Keep all transmitters and receivers at least 3 m away
from each other.
1 Set the POWER 1 or POWER 2 switch to ON.
2 Press the MENU button to display the RX1 or RX2
menu, and press the + or – button to display the GP/
CH screen.
3 Press and hold the SET button for 1 second or longer.
The channel group display starts flashing.
4 Use the + or – button to select the desired group
name, then press the SET button.
The channel group is set, and the channel number
display starts flashing.
5 Use the + or – button to select the desired channel
number, then press the SET button.
The displays stops flashing and the desired channel is
set.
• If there is no user input within 10 seconds after the
channel group display or channel number display starts
flashing, the displayed setting that is flashing is saved.
The same applies when setting other parameters.
• The frequency indicator changes in response to the
channel number.
• The unit continues to receive, even when setting the
receive channel.
• If the power supply cuts off while you are configuring
settings, perform the configuration procedure again
from the beginning.
• Make sure that the same channel is set on transmitters
and receivers within the same system.
Searching for Available Channels
within a Group (Clear Channel
Scan)
You can search for available channels within the
specified channel group.
Before performing this procedure, select the channel
group.
For details, see “Setting the Receive Channel” (page 9).
1 Press the MENU button to display the RX1 or RX2
menu, and press the + or – button to display the CLR
SCAN screen.
2 Press and hold the SET button for 1 second or longer.
Press and hold until the channel group and “+”
display starts flashing.
3 Press the + button.
The unit starts to scan through the selected channel
group. When available channels are found, the first
channel number among the available channels starts
flashing on the display.
To display the next available channel number
Press the + button.
To cancel searching
Press the – button. The display returns to the CLR
SCAN screen.
4 Press the SET button when the desired channel
number starts flashing.
Note
Notes