VPCEA Series Optical Disk Drive Replacement Instructions

VPCEA Series Optical Disk Drive

Replacement Instructions

P/N 989201977 Rev. B 1/3

Prepare the Computer

CAUTION: Make sure the

computer is turned off, the lid is

closed, and the AC Adapter is

disconnected. Failure to do so can

result in damage to the computer.

Step 1. Place the computer upside

down on a protected surface with the

front edge facing you.

Battery Pack Removal

Step 2.

1) Slide the left battery tab to the

unlock position.

2) With your right thumb, slide the

right battery tab to the left and hold.

Lift the battery with your left thumb

using the notch at the bottom to

remove.

Optical Drive Removal

(Steps 3-6)

Step 3. The Optical Disk Drive (ODD)

is located on the left side of the unit

as shown.

These easy instructions are intended to guide you through the replacement process.

 Before you begin, place your notebook computer on a clean or covered surface to avoid

damage to the computer's case.*

 Follow the ESD (Electrostatic Discharge) damage prevention instructions:

o Hold parts by the edges, away from exposed circuitry when possible.

o Do not walk around excessively as this promotes static build-up.

 Before you begin, remove any jewelry you may be wearing to prevent scratches to the surface

of your notebook computer.*

 The appearance of the electronic components shown in the illustrations may be different from

the components shipped. This slight difference does not affect the accuracy of these

instructions.

* Sony is not responsible for damage caused by incorrect handling of the notebook computer.

IMPORTANT!

PLEASE READ BEFORE YOU START

Lift to remove

PAGE 1
VPCEA Series Optical Disk Drive Replacement Instructions IMPORTANT! PLEASE READ BEFORE YOU START These easy instructions are intended to guide you through the replacement process. Before you begin, place your notebook computer on a clean or covered surface to avoid damage to the computer's case.* Follow the ESD (Electrostatic Discharge) damage prevention instructions: o o Hold parts by the edges, away from exposed circuitry when possible.
PAGE 2
VPCEA Series Optical Disk Drive Replacement Instructions Step 4. Using the enclosed magnetic screwdriver, remove the two (2) screws securing the ODD Bay. Put aside the ODD Bay screws to re-secure the ODD Bay later in the procedure. Step 5. Insert your fingers in the space between the ODD and the unit. Gently pull towards the Left to remove the ODD. Step 6. Carefully remove the ODD Assembly from the unit. ODD Disassembly (Steps 7-9) Step 8. Remove the screws & brackets.
PAGE 3
VPCEA Series Optical Disk Drive Replacement Instructions Right Back Step 12. Position the new ODD (Label side down) and identify the correct Bracket with the corresponding ODD side (as shown). Take note of the different shapes for each bracket and the proper alignment of the screw holes. Step 13. Using the ODD Screws, install the ODD Brackets onto the new ODD. NOTE: After installation, all brackets should sit flush with the ODD.