User Guide

29
GB
Other Functions
Convenient Function
If you are leaving the conference room
immediately, turn the projector off, and then,
after the lens protector closes and the
powered tilt adjuster is put away in the
projector, you can unplug the AC power
cord. After the AC power cord is unplugged,
the fan runs for a certain time automatically.
• When unplugging the AC power cord, ensure
that the lens protector closes and the powered
tilt adjuster is put away in the projector.
Moving the projector with the powered tilt
adjuster rised may damage the adjuster.
• Turn off the projector according to the
procedure in “Turning off the power”, then
cool it down when storing the projector in the
carrying case.
• However, if the unit has been on for less than
15 minutes, the fan might not begin to turn as
a result of inadequate charging. In that case,
follow the procedure for turning off the
power as described in “Turning Off the
Power” on page 25.
To enlarge the image (Digital Zoom
function)
You can select a point in the image to
enlarge. This function works when a signal
from a computer is input, or when a still
picture (except a movie picture) stored in a
Memory Stick is projected.
This function does not work when a video
signal is input.
1 Project a normal image, and press the
D ZOOM + key on the Remote
Commander.
The digital zoom icon appears in the
center of the image.
2 Move the icon to the point on the
image you want to enlarge. Use the
arrow key (M/m/</,) to move the
icon.
3 Press the D ZOOM + key again.
The image where the icon is located is
enlarged. The enlargement ratio is
displayed on the screen for a few
seconds.
By pressing the + key repeatedly, the
image size increases (ratio of
enlargement: max. 4 times.)
Use the arrow key (M/m/</,) to
scroll the enlarged image.
To return the image back to its
original size
Press the D ZOOM – key.
Just pressing the RESET key returns the
image back to its original size immediately.
To freeze the image projected
(Freeze function)
Press the FREEZE key. “Freeze” appears
when the key is pressed. This function works
when a signal from a computer is input or
when a still picture stored in a Memory
Stick is projected.
To restore the original screen, press the
FREEZE key again.
Off & Go Function
Notes
Effective Tools for Your
Presentation
Digital zoom
icon