Operation Manual

11
Projecting an Image
Projecting/Adjusting an Image
Adjusting the tilt of the projector with the adjusters
By changing the tilt of the projector with adjusters, you can adjust the position of the projected
image.
1 Press and hold the adjuster button, then
lift up the front of the projector to adjust
the angle.
2
When the desired angle is achieved,
release the adjuster button to lock the
position.
3 Set the angle of the projector precisely
by turning the two rear adjusters.
• Be careful not to let the projector down on your fingers.
• Do not push hard on the top of the projector with the adjuster extended.
• Do not forcedly turn the rear adjusters more than they should be adjusted. Doing so may break
them.
Changing the aspect ratio of the projected image
Press the ASPECT key on the remote commander to change the aspect ratio of the projected
image. You can also change the setting in Aspect of the Screen menu (pages 16, 18).
Notes