Operating Instructions
Table Of Contents
- Table of Contents
- Location of Controls
- Connections and Preparations
- Projecting
- Using the Menus
- Using Network Features
- Error Handling
- Others
- Updating the Software
- About the x.v.Color
- About the simulated 3D feature
- Replacing the Lamp and the Air Filter and Cleaning the Ventilation Holes (intake)
- Cleaning the Air Filter
- Fitting the Lens Cap
- Cleaning
- Specifications
- Projection Distance and Lens Shift Range
- Dimensions
- NOTICES AND LICENCES FOR SOFTWARE USED IN THIS PRODUCT
- Index
41
On-screen display
Remote control
3D video images
Image is left on the
screen. (image retention)
When high contrast non-moving images are displayed for a
long period of time, there may be some image retention on
the screen. This is only a temporary condition. Turning off
the power for a while will eliminate the retained image.
–
Symptom Cause and Remedy Page
On-screen display does
not appear.
Set “Status” on the Setup menu to “On.” 29
Check if the ON/STANDBY indicator should light in green.
When the ON/STANDBY indicator blinks in green, the unit
is starting up. Wait until it stops blinking and remains lit in
green.
8
The model name does not
disappear from the
screen.
The display mode of the unit may be set at the time of
purchase. Consult with your local dealer or qualified Sony
personnel.
–
Symptom Cause and Remedy Page
The remote control does
not work.
Batteries could be weak. Replace them with new batteries. –
Insert the batteries with the correct polarities. –
If there is a fluorescent lamp near the remote control
detector, the unit may work improperly or inadvertently.
–
Confirm the position of the remote control detector on the
unit.
4
Symptom Cause and Remedy Page
The video image does not
seem like 3D video
images.
Check if the 3D glasses are turned on. 15
Make sure that the battery in the 3D glasses could be weak
or is sufficiently charged.
–
Set “2D-3D Display Sel.” to “Auto” or “3D.” 30
Check if the input signals are compatible 3D signals. 55
The 3D signals may not be input depending on the
specifications of the connected AV selector/AV amplifier/
external equipment. If the 3D signal is not input, confirm
the specifications and/or settings of the AV selector/AV
amplifier/external equipment.
–
When the viewing position is too far from the unit, the 3D
glasses may not be able to display the images properly.
15
The screen size is not appropriate. Set the zooming
magnification to low or watch the image from farther away
from the screen.
60
For details, see “Precautions for use” of “Using the 3D
Glasses.”
15
Symptom Cause and Remedy Page