User Guide

Changing the Lens

Position for Rear

Projection (Optical Axis

Angle: 0 degree)

For rear projection, you can set the optical axis angle

to 0 (zero). In this case, you will need to set the lens

position as follows.

You can install the following types of lenses for a zero

optical axis angle.

• Standard lens

• VPLL-ZM102 Long Focus Zoom Lens

• VPLL-FM22 Fixed Short Focus Lens

• VPLL-ZM32 Short Focus Zoom Lens

1 Turn off the power and disconnect the power

cable.

2 Remove the screw from the bottom of the unit by

using a Philips screwdriver .

(single long screw (M3))

3 Slide the top cover (top lens cover) forward, and

then lift it up to remove.

4 Remove the lens hood locking the lens by

loosening the four screws (M3×10, with washers)

with a Philips screwdriver.

9 Slide the top cover back until it makes contact

with the rear side.

Tighten the screw (single long screw (M3)) in

the bottom base.

Note

• The lens scratches easily, so when handling it,

always place it gently on a stable and level surface in

a horizonal position.

• Avoid touching the lens surface.