Operating Instructions
Table Of Contents
- Table of Contents
- Location of Controls
- Connections and Preparations
- Projecting
- Using the Menus
- Using Network Features
- Error Handling
- Others
12
• Use a Premium High Speed HDMI cable. If you use other types of cables, 4K video may not be
displayed appropriately.
• When connecting an HDMI cable to the unit, make sure the
V mark on the upper part of the HDMI
input of the unit and the v mark on the connector of the cable is set at the same position.
• If the picture from equipment connected to the unit with an HDMI cable is not correct, check the
settings of the connected equipment.
• If you set your computer, such as a notebook type, to output the signal to both computer’s display
and this equipment, the picture of the equipment may not appear properly. Set your computer to
output the signal to only the external monitor. For details, refer to the computer’s operating
instructions supplied with your computer. For settings of the computer, consult with the
manufacturer of the computer.
Notes
When you monitor and control the projector via the network, access the Setup page of the projector
(page 39) via a Web browser and enable the desired control protocol.