User Guide

48
scattered, if you do not reverse the
projector. This may cause injury.
• Be sure that the projector is placed on a
stable surface.
3 Loosen the screw on the lamp cover
with a Philips screwdriver, and then
open the lamp cover.
4 Loosen the 3 screws on the lamp with
the Phillips screwdriver. Hold up the
handle, then pull the lamp straight out.
5 Hold the handle of the new lamp and
push it in securely until it reaches the
end, and then tighten the 3 screws.
Be careful not to touch the optical block
inside the unit.
6 Close the lamp cover, then tighten the
screws.
Note