User Manual

Hint

The above procedure is an example. For more details, refer to the operating instructions supplied with the iPhone.

To delete all Bluetooth pairing information, see “Initializing the headset to restore factory settings”.

Note

When registering a device (pairing), [WF-1000XM3], [LE_WF-1000XM3], or both may be displayed on the connecting device.

When both or [WF-1000XM3] is displayed, select [WF-1000XM3]; when [LE_WF-1000XM3] is displayed, select [LE_WF-

1000XM3].

If pairing is not established within 5 minutes, pairing mode is canceled. In this case, start the operation over from step 1.

Once Bluetooth devices are paired, there is no need to pair them again, except in the following cases:

Pairing information has been deleted after repair, etc.

Select the Bluetooth setting on the iPhone.

Select [Settings].

Touch [Bluetooth].

Touch the switch to turn on the Bluetooth function.

Touch [WF-1000XM3].

If passkey (*) input is required, input “0000”.

The headset and iPhone are paired and connected with each other. You will hear voice guidance “Bluetooth

connected” from the left unit.

If they are not connected, see “Connecting to a paired iPhone ”.

If [WF-1000XM3] does not appear on the display, try again from step 4.

A Passkey may be called “Passcode”, “PIN code”, or “Password”.