User Guide

When multiple devices are selected for update
If a device update fails during the process, the following message may appear.
To attempt to update the device whose update failed, click [Retry]. To skip the device whose update failed and move to
the update process for the next device, click [Skip]. To exit the update process, click [Abort].
When a message is displayed after an unsuccessful update
If a previous attempt to update an Ethernet connection device was unsuccessful, the following message may appear
after selecting a package file.
To run the update process using the IP address specified during the unsuccessful update attempt, click [Yes]. The
information for the previous update attempt is deleted if you click [No]. In this case, click [Direct IP], specify the IP
address directly or select the IP address of the target device from the pull-down list, and then apply the update.
For USB connection devices, only a message appears.
Turn off the connected device, turn the device on again, and check the version of the device.
For details about checking the version, refer to the operating instructions of the device.
For devices for which an update failed, apply the update again, and check that the update is successful before use.
8
13