Owner's Manual

For
safety, be sure to install
this unit in the
dashboard
of
the car
as
the rear side
of
the
unit
becomes
hot
during use.
·For
details,
see
"Connection/Installation"
(page
33).
This product
is
classified
as
a
Class
1 Laser product
under
IEC/EN
60825-1:2007 and
IEC/EN
60825-
1:2014
and
Class
I
Laser product under
21
CFR
Part
1040.10.
•
Emission Duration:
Continuous
•
Laser Output:
Less
than 55.8
~W
•
Wavelength:
775
nm to
800
nm
The nameplate indicating operating voltage, etc.,
is
located on the bottom
of
the chassis.
Warning
FOR THE
CUSTOMERS IN
THE
USA. NOT
APPLICABLE IN CANADA,
INCLUDING IN
THE
PROVINCE
OF
QUEBEC.
POUR
LES
CLIENTS
AUX
ETATS-UNIS.
NON
APPLICABLE
AU CANADA, Y
COMPRIS
LA
PROVINCE
DE
QUEBEC.
This equipment
has
been tested and found
to
comply with the limits for a
Class
B digital device,
pursuant
to
Part
15
of
the
FCC
Rules.
These limits are designed to provide reasonable
protection against harmful interference
in
a
residential installation. This equipment
generates, uses, and
can
radiate radio frequency
energy and,
if
not
installed
and used in
accordance with the instructions, may cause
harmful interference
to
radio communications.
However, there
is
no guarantee
that
interference
will
not occur in a particular installation.
If
this
equipment does cause harmful interference to
radio or television reception, which
can
be
determined by turning the equipment
off
and
on, the user
is
encouraged
to
try
to
correct the
interference by one or more
of
the following
measures:
- Reorient or relocate the receiving antenna.
-
Increase the separation between the
equipment and receiver.
-Connect
the equipment into
an
outlet on a
circuit different from
that
to
which the receiver
is
connected.
-Consult
the dealer or
an
experienced radio/TV
technician for help.
You
are
cautioned
that
any changes or
modifications not expressly approved in this
manual could void your authority
to
operate this
equipment.
This device complies with Part
15
of
the
FCC
Rules
and
Industry Canada's
licence-exempt
RSSs.
Operation
is
subject to the following
two
conditions:
(1)
This device may not cause interference; and
(2)
This device must accept any interference,
including interference
that
may cause undesired
operation
of
the device.
This transmitter must not be co-located or operated
in
conjunction with any other antenna or
transmitter.
Under
Industry Canada
regulations, this radio
transmitter may only operate using
an
antenna
of
a
type and maximum (or lesser) gain approved for
the transmitter by
Industry Canada.
To
reduce
potential radio interference to other users, the
antenna type and its gain should be
so
chosen
that
the equivalent isotropically radiated power (e.i.r.p.)
is
not more
t~an
that
necessary for successful
communication.
This equipment complies with
FCC/IC
radiation
exposure limits set forth for
an
uncontrolled
environment and meets the
FCC
radio frequency
(RF)
Exposure Guidelines and
RSS-102
of
the
IC
radio frequency
(RF)
Exposure rules. This
equipment has very low levels
of
RF
energy
that
is
deemed to comply
without
maximum permissive
exposure evaluation
(MPE).
CAUTION
The use
of
optical instruments with this product will
increase eye hazard.
For
the
State
of
California,
USA
only
Perchlorate
Material - special handling may apply,
See
www. dtsc.
ca.
g ov /haza rdouswaste
I
perch
I
orate
A\
WARNING:
Do
not
ingest battery,
~
Chemical
Burn Hazard.
The remote commander contains a
coin/
button
cell
battery.
If
the
coin/button
cell
battery
is
swallowed,
it
can
cause severe internal burns in just
2 hours and
can
lead to death.
Keep
new and used batteries away from children.
If
the battery compartment does not close securely,
stop using the product and keep
it
away from
children.
If
you think batteries
might
have been swallowed or
placed inside any part
of
the
body, seek immediate
medical attention.
Note
on
the
lithium
battery
Do
not expose the battery
to
excessive heat such
as
direct sunlight, fire or the like.