Owner's Manual

Notes
on
installing
the
connection
cable
RC-SR1
(not
supplied)
•
Refer
to
the
support
sites on
the
back cover
for
details,
then
connect each lead properly
to
the
appropriate leads. Making an
improper
connection
· may damage
the
unit.
•
Depending on
the
type
of
car,
be sure
to
insulate
the
unused leads
with
electrical tape
for
safety.
•
Do
not
connect this cable when
the
steering wheel
remote control
is
not
used.
• Consulting
the dealer or an experienced technician
for
help
is
recommended.
When using
the
wired
remote control
1
To
enable
the
wired
remote
control, set
[STR
CONTROL]
in
[STEERING]
to
[PRESET]
(page
20).
Installation
For
Japanese
cars,
see
"Mounting the unit in a
Japanese car" (page 36).
Mounting
the
unit with
an
installation
kit
(not
supplied}
You
can
use a
commercially available double
DIN
installation
kit. Choose an
installation
kit with the
following panel
frame size.
Larger than
172
mm
x
97
mm
(6
7/a
in
x
3
7/a
in)
(w/
h),
with
an
inner corner radius
of
less
than
0.5
mm
(1/32
in).
Note
Be
sure
to
use
the
supplied screws
CD.
To
dashboard/center
console
Installation
kit
(not
supplied}
36GB
Mounting the unit
in
a
Japanese
car
You
may
not
be able
to
install
this
unit
in some
makes
of
Japanese
cars.
In
such a
case,
consult your
Sony dealer.
When mounting this unit to the
preinstalled
brackets
of
Y'Our
car,
use the supplied screws
CD
in
the appropriate screw holes
based on your car:
T for
TOYOTA
and N for
NISSAN.
0
TIN
T/N
T
NO
0 0
Note
To
prevent malfunction,
install
only
with
the
supplied
screws
CD.
For
details,
see
"Resetting
the
Unit" (page
7).
When replacing the fuse, be sure
to
use one matching the
amperage rating stated on the
original fuse.
If
the fuse blows,
check the power connection and
replace the fuse.
If
the fuse
blows
again after replacement, there
may be an internal malfunction.
In
such a
case,
consult your nearest Sony dealer.