User Guide

13
Setting a Security Code
By setting a security code (password consisting of a 4-digit
number), you can prevent use of the unit by persons other
than the owner.
To set a security code
Follow the steps below with the card remote commander
while the monitor is open.
1
Press MENU.
2
Press V or v to select “Code Edit”.
C ode Ed i t
3
Press ENTER.
C ode Ed i t
Code :
4
Press V or v to select a numeral.
5
Press b to move to the next digit.
6
Repeat steps 4 - 5 until all digits are input.
7
Press ENTER.
C ode Ed i t
Yes :No
8
While the indication “Yes” is flashing, press
ENTER.
The security code is now set. When a security code is set, an
indication requesting input of the security code appears on
the display window when the unit is connected to the
battery after having been disconnected from the battery for a
long period of time.
Note
The security code input function operates
only when the unit is turned on after the
unit was disconnected from the battery
and any electrical charge remaining in
the unit has been completely dissipated.
If the unit is turned on again after a brief
interval while there is still a remaining
charge, the normal clock indication will
be shown and security code input is not
required.
ENTER
MENU
V/v
B/b