User's Manual

23GB
E:\4732062111\4732062111XAVAX5000UC\01GB-XAVAX5000UC\040CD.fm masterpage: Right
XAV-AX5000
4-732-062-11(1)
Troubleshooting
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check
the connection and operating procedures.
For details on using the fuse and removing the unit
from the dashboard, see “Connection/Installation”
(page 28).
If the problem is not solved, visit the support site on
the back cover.
General
No power is being supplied to the unit.
 Check the fuse.
 The connection is not correct.
– Connect the yellow and red power supply
leads.
There is no beep sound.
 An optional power amplifier is connected and
you are not using the built-in amplifier.
The contents of the memory have been erased.
 The power supply lead or battery has been
disconnected or it is not connected properly.
The fuse has blown.
The unit makes noise when the position of the
ignition is switched.
 The leads are not matched correctly with the car’s
accessory power connector.
The display disappears from/does not appear on
the monitor.
 The dimmer is set to [ON] (page 18).
 The monitor off function is activated (page 6, 7).
– Touch anywhere on the display to turn the
display back on.
Menu items cannot be selected.
 Unavailable menu items are displayed in gray.
Touch panel operation
The touch panel does not react to your touch
correctly.
 Touch one part of the touch panel at a time. If
two or more parts are touched simultaneously,
the touch panel will not react correctly.
 Touch the pressure sensitive panel firmly.
 The touch panel does not react when touching
with wet fingertips or when water droplets are on
the touch panel.
Multi touch does not be recognized.
 Multi touch operation is not supported on this
unit.
Radio reception
The stations cannot be received.
The sound is hampered by noise.
 The connection is not correct.
– Connect the REM OUT lead (blue/white striped)
or accessory power supply lead (red) to the
power supply lead of a car’s antenna (aerial)
booster (only when your car has built-in radio
antenna (aerial) in the rear/side glass).
– Check the connection of the car antenna
(aerial).
– If the auto antenna (aerial) will not extend,
check the connection of the power antenna
(aerial) control lead.
Preset tuning is not possible.
 The broadcast signal is too weak.
RDS
PTY displays [PTY not found.].
 The current station is not a RDS station.
 RDS data has not been received.
 The station does not specify the program type.
Picture
There is no picture/picture noise occurs.
 A connection has not been made correctly.
 Check the connection between this unit and
other equipment and set the input selector of the
equipment to the source corresponding to this
unit.
 Installation is not correct.
– Install the unit at an angle of less than 45° in a
sturdy part of the car.
 The parking cord (light green) is not connected to
the parking brake switch cord, or the parking
brake is not applied.
The picture does not fit in the screen.
 The aspect ratio is fixed on the playback source.
010COV.book Page 23 Tuesday, August 29, 2017 11:10 AM